Paint Brush Stand

This is a work in progress, but it is functional. I'm not completely satisfied by how much friction I'm getting so I may update it in the near future after I've used it for a while.

This model is designed to hold your paint brushes vertically, tip down. You will need a rubber band (the one I used is 210mm long) and some extra 1.75mm filament in addition to the parts here.

Note: Many printers will over-fill the holes for the filament to feed through. This depends on many factors (cooling, material used, extrusion temperature, printer calibration). It's easy enough to print as is and then take a 1/16 drill bit to clean out the holes in the enclosure, cover, and clips.

Print all the parts without supports. You will need 16 clips, 1 base, 1 enclosure, and 1 cover. Cut 16 pieces of filament about 20mm long (minimum of 10mm but having them longer is easier to work with). Before starting, it's useful to put a rock in the center of the base to make it more stable and easier to operate