Paintbrush Holder 02
382
Downloads
288
Likes
3
Makes
As a followup to our first paintbrush holder, [Paintbrush Holder 01](https://www.thingiverse.com/thing:3586078), we made another one, similarly titled Paintbrush Holder 02. This one is a bit more bean-shaped, with a small dish at the bottom for... small dish-shaped things (like a texturing sponge, say).
This one again uses 1/2" ID copper tubing (~.625" OD) as support, adds an additional support, and the afore-mentioned small dish. The outer track has 27 slots, the inner track has 6 slots. The support tubes can be used as storage, or filled with sand and epoxied/hot-glued for some additional heft.
It was designed for relatively small paintbrushes (especially those tiny outer-track side holes) but the outer-most inner track will hold a Sharpie with a pocket clip, all holes will fit a pencil, etc. so it can double as a somewhat-niche desk dongle as well.
We had a few questions about the design of this so we did another quick walkthrough of "Pattern on Path" and how to resolve one
This one again uses 1/2" ID copper tubing (~.625" OD) as support, adds an additional support, and the afore-mentioned small dish. The outer track has 27 slots, the inner track has 6 slots. The support tubes can be used as storage, or filled with sand and epoxied/hot-glued for some additional heft.
It was designed for relatively small paintbrushes (especially those tiny outer-track side holes) but the outer-most inner track will hold a Sharpie with a pocket clip, all holes will fit a pencil, etc. so it can double as a somewhat-niche desk dongle as well.
We had a few questions about the design of this so we did another quick walkthrough of "Pattern on Path" and how to resolve one
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!