Thingiverse

Paintbrush Holder

von Fifinator

43 Downloads

33 Likes

0 Makes

A paint brush holder with a snap on handle! (similar to old candle holders). The hollow Cylinder snap-fits into the Bottom part, the Top part then snap-fits into the Cylinder, and the handle snap-fits into the Top part (lots of fun snapping!). Handle snap-fits into any of the 4 sides.

Holder keeps the brushes standing perfectly straight so that the softer bristles aren't damaged.

Fits 24 Brushes (Hole diameters below):
12 holes at 7mm
8 holes at 9.9mm
3 holes at 9mm
1 hole 14.5mm

I printed:
- Bottom Body at 20% infill
- Cylinder at 20-30% infill
- Top Body at 60% infill
- Handle at 80% infill (Only the handle needs support - very little of it)

Top/Bottom/Wall Layer = 3

miniature painting model painting Model Paint holder paint paintbrush paintbrush holder paintbrush organizer paintbrush stand painting paint brush holder paint brush stand miniature painting model painting Model Paint holder paint paintbrush paintbrush holder paintbrush organizer paintbrush stand painting paint brush holder paint brush stand

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Warum?

Supports nötig

Einteilig Supports nötig

Supports 2/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker