Thingiverse
Paintbrush Holder
door Sam4399
88
Downloads
73
Likes
2
Makes
prints fine at whatever solution you want
infill is also negligible but i would say 10-60% is fine everything above is overboard
to connect it just heat both pieces with the hotbed a little and then twist the top carefully into the bottom part
i hope you like it as much as i do
have fun printing ^^
infill is also negligible but i would say 10-60% is fine everything above is overboard
to connect it just heat both pieces with the hotbed a little and then twist the top carefully into the bottom part
i hope you like it as much as i do
have fun printing ^^
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
