Thingiverse
Painters Hawk
door Bliv
1
Downloads
2
Likes
0
Makes
I didnt want to spend $40au on a Painters hawk to mix dry wall/gyprock powder and fill a few small holes in my interior walls so i designed this one in Onshape and printed my own.
Printed on a smooth plate using PETG so it can be washed clean after use.
I added 3 small feet so it can be temporarily put down without the handle and leave enough room to get your fingers under it to pick it up when ready to use again.
EDIT: added an improved version thats square so you can scrape your spatula clean on the straight edge of the hawk. (cant do this on the round one)
Printed on a smooth plate using PETG so it can be washed clean after use.
I added 3 small feet so it can be temporarily put down without the handle and leave enough room to get your fingers under it to pick it up when ready to use again.
EDIT: added an improved version thats square so you can scrape your spatula clean on the straight edge of the hawk. (cant do this on the round one)
Bliv publiceert ook op
16 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
