Palette 2 custom stand

I design this because i want something to lift up my Palette 2 off the ground.
It sits on the floor next to my printer and the included kickstand just doesnt do it for me.

Included parts :

* Rear bracket upright - Print as loaded with support for the bracket
* Right bracket - rotate on its flat side. Print one then mirror and print another for the left.

*** Rear bracket upright s3dfixed. Seems s3d (simplify 3d slicer) didnt see it as one solid
piece..
Download this file if your using s3d.

---Check the photos. You slice should look like the cura photo (old file) or s3d top (new file).
Cura and slic3r will work fine for the first file so no need to redownload if you use them.

It uses 2x m3 bolts and nuts
The m3 nuts will need to be at lest 30mm long. The rear bracketed has a hole all the way throught.
The nut traps are on the tight side, meant to be a press in. Depending on your printer you might have to heat the nuts up a little and push them in.