Thingiverse
Palette 2 Upside Down Wall Mount
por zyrain
4
Descargas
1
Likes
1
Makes
I wanted to mount my Palette 2 on the wall, upside down so that spools feed from the top, through the palette to my printer. The palette is tipped back against the wall so it won't tip forward, and is very secure.
The lid is removable, and the brackets don't interfere with the SD card.
I created and tested these little brackets. They should be more than sufficient for holding the weight, even when printed in PLA (tested with load simulation up to 100Kg!)
Printing the cross-bar is optional. I used 4.5 mm screws, drywall anchors, and 13mm washers (in the supplied insets).
The Combined .STL has all three parts in one file. The .ZIP has separate parts, and there is also a sliced GCODE file if you have a MK3.
The lid is removable, and the brackets don't interfere with the SD card.
I created and tested these little brackets. They should be more than sufficient for holding the weight, even when printed in PLA (tested with load simulation up to 100Kg!)
Printing the cross-bar is optional. I used 4.5 mm screws, drywall anchors, and 13mm washers (in the supplied insets).
The Combined .STL has all three parts in one file. The .ZIP has separate parts, and there is also a sliced GCODE file if you have a MK3.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
