Thingiverse
Palette+ SD Card Guide
by jmcbassett
4
Downloads
5
Likes
0
Makes
Due to some clumsiness I managed to drop the SD card inside my Palette+. it can be tricky due to the lack of a guide, just a hole in the case with the socket somewhere inside.
Additionally less than 1 mm of the SD Card protrudes outside the case of the Palette+, which makes remove fiddly; this was simply fixed by putting a piece of clear tape on the back edge of the SD card.
This model was created to sit inside the case of the Palette+, locating on 2 of the display PCB mounts. It guides the card in to the socket.
I've included the OpenSCAD file to other to tweak the design if needed .
Additionally less than 1 mm of the SD Card protrudes outside the case of the Palette+, which makes remove fiddly; this was simply fixed by putting a piece of clear tape on the back edge of the SD card.
This model was created to sit inside the case of the Palette+, locating on 2 of the display PCB mounts. It guides the card in to the socket.
I've included the OpenSCAD file to other to tweak the design if needed .
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
