Thingiverse
Palm Tree
door Curufin
4.5k
Downloads
2.6k
Likes
16
Makes
Shipwrecked? Buried treasure? Pirates? Long walks on the beach? Sounds like you might just need some Palm Trees! These palm trees print in a number of small pieces so you can assemble a tree as tall or as short and you like, as straight or as bendy as you like. All the parts print flat and are scale-able. The Palm Tree on the right was printed and 100%, the Palm Tree on the left was printed at 80%.
Assembly Instructions:
Start with a base section (straight or curved), to that glue any number of Straight, Curved, or Tight Curved Sections to create the style of tree trunk you like. To that add one of the Husk Sections, followed by the Top. Glue the Assembled Palm Tree Trunk down to one of the Bases (if the Trunk is quite bendy, use the Large Base). Print 8 Large Leaves, 8 Leaves, and 4 Small Leaves. Put all the Leaves into a bowl of near boiling water. One by one, pull one leave out and shape it with you hands. CAUTION: BE CAREFUL WHEN WORKING WITH HOT WATER
Assembly Instructions:
Start with a base section (straight or curved), to that glue any number of Straight, Curved, or Tight Curved Sections to create the style of tree trunk you like. To that add one of the Husk Sections, followed by the Top. Glue the Assembled Palm Tree Trunk down to one of the Bases (if the Trunk is quite bendy, use the Large Base). Print 8 Large Leaves, 8 Leaves, and 4 Small Leaves. Put all the Leaves into a bowl of near boiling water. One by one, pull one leave out and shape it with you hands. CAUTION: BE CAREFUL WHEN WORKING WITH HOT WATER
Curufin publiceert ook op
86 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
