PAM8406 Bluetooth Speaker Case

Case for this Bluetooth speaker DIY soldering kit which you can find in various places: PAM8406 Bluetooth DIY speaker kit, spectrum, USB electronic amplifier, dual channel stereo, with Bluetooth level indicator lighthttps://www.aliexpress.com/item/1005007449494581.htmlDIY Bluetooth Speaker Kit Dual Channel PAM8406 Power Amplifier Soldering Kithttps://www.ebay.co.uk/itm/395524209612 You can find a lot of similar kits, but specifically this is the one with the dial for the volume.There are printed pegs on which to hang the speakers, and there are holes under where the circuit board sits. I used these holes to fit pegs from small pieces of filament (use something flat to push them in) then a bit of hot glue on all the pegs to secure the components. The print profiles are set up for normal PLA. In the example photos I have printed in translucent PETG, if you want that see-through effect you will need to modify your print profile to use the bambu wiki settings: https://wiki.bambulab.com/en/