Thingiverse
Pampered Chef Knife Sleave
von Fantome
0
Downloads
0
Likes
0
Makes
These knives are really sharp and I always worry about getting stabbed when I put them away in their original holders. I made this simple cover to replace the original. It is much safer.
It prints in vase mode, 0.2mm layer height. I found 0.3 produces weak layer adhesion so I recommend 0.2mm layer height. I used PETG.
The hollow model is for those who don't like vase mode. Print it at 0.2mm height as well.
I included the FreeCad files because everyone who isn't rich and wants to learn 3D modelling should learn to use FreeCad.
It prints in vase mode, 0.2mm layer height. I found 0.3 produces weak layer adhesion so I recommend 0.2mm layer height. I used PETG.
The hollow model is for those who don't like vase mode. Print it at 0.2mm height as well.
I included the FreeCad files because everyone who isn't rich and wants to learn 3D modelling should learn to use FreeCad.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
