Thingiverse
Panasonic GH4 Cage
di Bram1982
137
Download
107
Likes
5
Makes
Small update 13-05-2018
-Now with locking feature by using the hotshoe mount of the camera for extra rigidity!
-Improved accessibility ISO button
-Made the hotshoe mount width smaller to better fit accesories
-Extra screw mount near HDMI port
-Extra screw mount near cold shoe mount
-Screw mount on the right made horizontal instead of angle
-Very minor dimensions adjustments for better fit.
-Print in PETG for less warping with 85% infill
-Removed the 2 pads
-Simplify3D: make sure to select "Merge all outlines into single model" in the advanced tab!
END OF UPDATE
This is a cage/armor for the Pananonic GH4 Photo / movie camera. Make sure you get good bed adhesion or else the edges might curl up a bit when printed in ABS. I recommend kapton tape + hairspray. Print at about 85% infill for added strength and use supports. Use a vile + sandpaper to clean up the print afterwards and give it an acetone vapor treatment for a pro look!
Add the 3/8th to 1/4th inch screw threa
-Now with locking feature by using the hotshoe mount of the camera for extra rigidity!
-Improved accessibility ISO button
-Made the hotshoe mount width smaller to better fit accesories
-Extra screw mount near HDMI port
-Extra screw mount near cold shoe mount
-Screw mount on the right made horizontal instead of angle
-Very minor dimensions adjustments for better fit.
-Print in PETG for less warping with 85% infill
-Removed the 2 pads
-Simplify3D: make sure to select "Merge all outlines into single model" in the advanced tab!
END OF UPDATE
This is a cage/armor for the Pananonic GH4 Photo / movie camera. Make sure you get good bed adhesion or else the edges might curl up a bit when printed in ABS. I recommend kapton tape + hairspray. Print at about 85% infill for added strength and use supports. Use a vile + sandpaper to clean up the print afterwards and give it an acetone vapor treatment for a pro look!
Add the 3/8th to 1/4th inch screw threa
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!