Thingiverse
Panasonic GH4 Camera Cage
von noen
69
Downloads
41
Likes
0
Makes
This is a cheese grate camera cage for the Panasonic GH4.
https://www.thingiverse.com/thing:1691475 was the inspiration for this cage, but this was measured and modeled from my camera from scratch.
This cage has a proper hotshoe catch to completely lock the camera in position.
You'll need to use a drill to ream the holes to proper tap spec for 1/4" and 3/8" taps. If you print with PETG or ABS, and drill then tap each hole, there's more than enough grip to use them without brass inserts.
I printed this with 85% infill and 3 perimeters with PETG to produce an essentially solid part.
https://www.thingiverse.com/thing:1691475 was the inspiration for this cage, but this was measured and modeled from my camera from scratch.
This cage has a proper hotshoe catch to completely lock the camera in position.
You'll need to use a drill to ream the holes to proper tap spec for 1/4" and 3/8" taps. If you print with PETG or ABS, and drill then tap each hole, there's more than enough grip to use them without brass inserts.
I printed this with 85% infill and 3 perimeters with PETG to produce an essentially solid part.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
