MakerWorld
Animals
Voir le modèle
Panda Keychain / Panda Keychain
29
Téléchargements
41
Likes
10
Makes
This is a mold for recycling 3D printing waste (PLA) to create a panda keychain, printed using PETG. It can recycle 9-10 grams of plastic at a time. Tools needed: oven, 3M respirator mask, silicone baking tray, small pliers, flat screwdriver, hammer. Production process:Place 9-10 grams of PLA in the oven and heat at 210°C for about 10 minutes.Pour the melted plastic into the mold, insert the piston, and press down firmly or step on it for 15 seconds.After about 5 minutes, wear gloves and open the mold. (If the mold is difficult to open, you can use a flat screwdriver and hammer to pry it open.)Remove the burrs, punch holes, and install the keychain. 这是一个回收3D打印废料(PLA)制作熊猫钥匙链的模具,使用PETG打印。它一次可以回收9~10g塑料。 需要的工具:烤箱,3M防毒面罩,硅胶烤盘,小钳子,平起子,锤子。 制作流程: 1,把9~10克PLA放入烤箱,210℃加热约10分钟。 2,把熔化的塑料放入模具,插入活塞,用力按压或踩15秒。 3,约5分钟后,带好手套,打开模具。(如遇脱模困难,可使用平起子和小锤子撬动模具。) 4,去除毛边,打孔,安装钥匙链。
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !