MakerWorld
Hueforge & Lithophane
Model downloaden
Panda
18
Downloads
15
Likes
3
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.2mm Filaments Used:PLA PolyLite Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Matte Dark Brown Transmission Distance: 2PLA PolyLite Grey Transmission Distance: 1PLA PolyLite White Transmission Distance: 5This print uses 5 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #8 (0.72mm) swap to Blue GrayAt layer #11 (0.96mm) swap to Dark BrownAt layer #14 (1.2mm) swap to GreyAt layer #18 (1.52mm) swap to White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!
Corp publiceert ook op
338 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
