Thingiverse
PandaPi V2.0 Raspberry Enclosure
von Gabydou
2
Downloads
0
Likes
0
Makes
This is my remix off the pandaPi enclosure base on this one
mine is made to work on the Raspberry Pi 4B with the panda V2.0 version
the cover hole is made to print without support and if yours bridge is on point you can print almost without support (exept for the 40x20 alluminium mount)
08-05-2021 Update Add of a version made for the 3B Raspberry to (i only change te hole frome the ethernet port to the usb. at your own print)
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
mine is made to work on the Raspberry Pi 4B with the panda V2.0 version
the cover hole is made to print without support and if yours bridge is on point you can print almost without support (exept for the 40x20 alluminium mount)
08-05-2021 Update Add of a version made for the 3B Raspberry to (i only change te hole frome the ethernet port to the usb. at your own print)
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
