Slicer Discord
Panel Dacia Duster 2018 – 3D-Druckmodell von Thingiverse Thingiverse
Panel Dacia Duster 2018 – Bild 1 Panel Dacia Duster 2018 – Bild 2 Panel Dacia Duster 2018 – Bild 3 Panel Dacia Duster 2018 – Bild 4 Panel Dacia Duster 2018 – Bild 5 Panel Dacia Duster 2018 – Bild 6
Automotive

Panel Dacia Duster 2018

33 Downloads
41 Likes
0 Makes
Zum Modell
I wanted replace the original panel of my Dacia Duster 2108 with a one with more connection. The panel is flat so it is simple to draw, I added another cig-plug, a double USB with voltmeter, an XT60 for high current use, a light for the tunnel with his switch. The panel can be printed in normal pla for semplicity but if you leave your car under the sun for many hours there is the risk of deformation. I have not tested to print it with ABS but I presume is a good idea. I used instead a High Temperature PLA from Paperdifferent. In this way, after the print, the material can be hardened keeping it for 90 minutes at 90°. After this it can support over 100° with no deformations.
ATTENTION: If you use HT PLA you must scale the models to 101.25 because during the hardening process the material become a little narrow (for my HTPLA I used 101.25, the seller suggested 102 but was too much). There are same STL files, original panel, original panel with screw fixing (2 screws can be used from ca
Kategorie
Automotive
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ABS
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen