Thingiverse
Panel mount for push connect barrel plug
von blue_haniwa
1
Downloads
3
Likes
0
Makes
Panel mount for push connect barrel plug.
It's not normally intended to be mounted on a panel, but sometime you run out of the right part and want to finish your project.
An advantage of this design / plug is that it secure to the panel from inside so if sometime in the future you have to remove / disconnect it you don't have to de-solder anything.
After installing this print on your push connect barrel plug, use a ziptie to secure it.
Print note:
Rotate and print in the orientation showed in my screenshot, not the default orientation
It's not normally intended to be mounted on a panel, but sometime you run out of the right part and want to finish your project.
An advantage of this design / plug is that it secure to the panel from inside so if sometime in the future you have to remove / disconnect it you don't have to de-solder anything.
After installing this print on your push connect barrel plug, use a ziptie to secure it.
Print note:
Rotate and print in the orientation showed in my screenshot, not the default orientation
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
