Slicer Discord
Pangulon - Birdcage – 3D printable model from MakerWorld MakerWorld
Pets

Pangulon - Birdcage

by AlanSUN · Pets
14 Downloads
16 Likes
1 Makes
Go to Model
笼体使用烧烤的铁签,直径是1.62mm的,基本不用裁剪。 结构分为三个部分由下到上,底板-中框-顶盖。 一共分为5盘,含有横杆,食盒,顶盖预留了空位方便装提手,我使用的是麻绳,穿过去打两个死结即可。 烧烤签尽量选择不锈钢的那种,1是有韧性,2是耐腐蚀不生锈 更美观。 安装非常简单仅需要 一把钳子 一瓶502胶水即可,按照孔位将铁签穿入对应孔位即可,用钳子将每根签子插入顶底板深处,然后在孔位滴上502 食盒背面预留了直径8mm厚度3mm 的 n52磁铁孔,是为了避免小鸟将食盒踩翻,食盒边缘也做了加宽与倒角处理,小鸟抓握更舒适。 整体高度就是铁签的长度了,但是根据经验,铁签越长,安装越费时 整体美观度个人觉得还不错,是个养 虎皮 小太阳 玄风 这类的小体积,选择铁签是因为应为喙都很厉害而且基本都有啃咬笼子的情况。 注意:中框 中间是两排孔位,上半部分是直插的,下半部分是给门预留的,需要剪裁出 15cm签子作为门扇,背部食盒的靠山需要在底板安装完成后就提前装入!!!
Category
Pets
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection