Pantry Can Storage Rack

This is a rack for canned food items.

It works with 3 can heights and 3 can diameters.

For a Height you pick the correct Brace and Base files
For the Diameters, you pick the stacking legs Front and Rear.

Everyone uses the same Rail and Leg. The STLs are only for the right side. You will need to mirror the part in the slicer to print the left side.

I did make one special Height set of parts. the 103 Mixed. These allow you to use 103 height cans with the 114 height.

The bases and Leg have pockets for 3mm thick rubber feet.

Use CA/Super glue on the parts.
Specifically, mortis and tenon Joints. The Base to Rail pin should not be glued.

PLA > PETG in this case, both should work.