Paper Plate Holder

A simple paper plate holder for 9" plates. I printed at 0.32 layer heights using 3d Solutech PLA at 210C on my Creality CR-10. I used 3 shells and 3 top and bottom layers. I had to increase the extrusion width to 0.45 in Simplify3D so that it would print the hexes out properly At the usual 0.4 width, they were slightly disconnected and fell apart into a bunch of independent hexes. Pay careful attention to your preview to make sure you will get a solid plate. Total print time is around 5.5 hours.