Thingiverse
Paper Trimmer
by stephen_w
0
Downloads
4
Likes
0
Makes
I made a Paper Trimmer ,When use it, A ruler is needed as an aid.
installation instruction is shown in the picture.
special tips:
I need a wallpaper blade, and break off two parts with plier (see picture. ) after inserting blade.( Be careful your hand)
This model was printed using PLA. (fill in 10%，using a lower layer hight (0.15/0.2mm)，no support)
installation instruction is shown in the picture.
special tips:
I need a wallpaper blade, and break off two parts with plier (see picture. ) after inserting blade.( Be careful your hand)
This model was printed using PLA. (fill in 10%，using a lower layer hight (0.15/0.2mm)，no support)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!