Thingiverse
Parabolic Radar Assembly
por jlehman
43
Descargas
29
Likes
0
Makes
This is an assembly specifically designed for using in the Challenger Learning Center Sim. It fits onto the top of a small probe module. During a mission, the Probe (or SAT) Team would find the top part damaged by meteor strike, and would need to print another one at the direction of Mission Control. The top part takes approximately 20 minutes to print. The other parts only need to be replaced when the break or are lost. I plan to print a number of top pieces and damage them with hot needles to simulate meteor strikes, and put them on before the mission so the crew finds them pre-damaged.
Note: the ring that fits over the front has a thicker rim at one side. It should be put on big-side first,
Note: the ring that fits over the front has a thicker rim at one side. It should be put on big-side first,
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!