Thingiverse
Parallax Adjuster Ring Helper
por Gadjet0
12
Descargas
5
Likes
0
Makes
This is a helper ring to fit to my Nikko Sterling telescopic sight fitted to my air rifle.
It's designed for my 50mm AO Objective lens.
It's printed in ABS but no reason why PLA wouldn't do I suppose
The one I printed was quite a tight fit but some earlier ones were too loose so you may need to take the edges of the radii off with a bit of sandpaper depending on how accurate you printer is.
It's designed for my 50mm AO Objective lens.
It's printed in ABS but no reason why PLA wouldn't do I suppose
The one I printed was quite a tight fit but some earlier ones were too loose so you may need to take the edges of the radii off with a bit of sandpaper depending on how accurate you printer is.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!