Thingiverse
Hobby
Go to Model
Parallel Gripper for EEZYbotARM MK2
305
Downloads
288
Likes
2
Makes
This is a remix of my [Rov Manipulator (Parallel Gripper)](https://www.thingiverse.com/thing:4362236) modified to fit the [EEZYbotARM MK2](https://www.thingiverse.com/thing:1454048) robotic arm and be controlled by a servo instead of a rotating shaft.
Use a SG90 Servo
**Hardware required** (See pictures for screw layout.)
*All screw holes are pre-tapped*
(4) 2-56 x 1/2" screws
(2) 4-40" x 3/8" Button Head Screws
(2) 4-40 x 1" Flat Head Screws
Servo Mounting screws.
Some of the parts will need to be oriented to be printed properly. See pictures for the layout I used. The fingers, forward hinges, and Pad need to be printed x 2. The finger pads were printed in a flexible filament for better grip but can be cut from rubber.
See https://www.theneverendingprojectslist.com/raspberrypiprojects/raspberrypiroboticarm/ for more info.
Use a SG90 Servo
**Hardware required** (See pictures for screw layout.)
*All screw holes are pre-tapped*
(4) 2-56 x 1/2" screws
(2) 4-40" x 3/8" Button Head Screws
(2) 4-40 x 1" Flat Head Screws
Servo Mounting screws.
Some of the parts will need to be oriented to be printed properly. See pictures for the layout I used. The fingers, forward hinges, and Pad need to be printed x 2. The finger pads were printed in a flexible filament for better grip but can be cut from rubber.
See https://www.theneverendingprojectslist.com/raspberrypiprojects/raspberrypiroboticarm/ for more info.
sthone also publishes on
101 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
