Slicer Discord
Parallel Marking Gauge Mk II – Modelo 3D imprimible de MakerWorld MakerWorld
Measure Tools

Parallel Marking Gauge Mk II

17.8k Descargas
6.9k Likes
11.2k Makes
Ver Modelo
This is the “Mark II” version of the Parallel Marking Gauge (or also scriber / ruler / t-square). It does exactly what it says - in increments of 1 mm (or 1/16th inch) - but this version comes with a flattened stop-block and markings on the back. This allows you to turn it around, place it against corners and draw parallel markings using the same holes. It is a somewhat demanding print and for best results it is highly recommended to use the provided print profiles on a clean build plate. There are 2 colour changes to highlight the markings, either done manually (pauses are set in profiles) or with an AMS. Versions: Metric Mk II 15 cm - 1mm interval,15 mm stop-blockMetric Mk II 25 cm - 1mm interval, 20 mm stop-block Imperial Mk II 6 inch - 1/16th interval, ¾ inch stop-blockImperial Mk II 10 inch - 1/16th interval, 1 inch stop-block You can find the original marking gauge here. It is simpler, needs only one colour swap to print but can only be used from one side. The gauge is designed f
Categoría
Measure Tools
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
¿Por qué?
2 colores
Pieza única 2 colores / AMS
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA, Wood PLA
Colores
2 (AMS/MMU recomendado)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección