Thingiverse
Parallella case v1.5
by GHM
9
Downloads
11
Likes
1
Makes
Updated based on recieved feedback. Thanks!
Better located vent holes, leaving a Wankel shaped interior covering the fan. Version 1.6 has two options, with a 50 x 10mm or 40 x 7 mm square 5V fan.
The height of the 40 mm version is just below 1", and the 50 mm version is 28 mm.
pic.twitter.com/X502FF5dc0
________________
Here is a case for parallella, as shown in
http://t.co/c2RCSFINnJ
http://t.co/99RKhu5Aob
Fan dimension is square 50 mm, height 10mm.
To keep i simple, no screws are needed. Fan is clipped in place, and pins together with the slide on lid holds the board.
UART pins must be bent 90 deg in order to slide the lid on. There is a gap on the side for attaching the wires.
Have fun with your parallella!
Better located vent holes, leaving a Wankel shaped interior covering the fan. Version 1.6 has two options, with a 50 x 10mm or 40 x 7 mm square 5V fan.
The height of the 40 mm version is just below 1", and the 50 mm version is 28 mm.
pic.twitter.com/X502FF5dc0
________________
Here is a case for parallella, as shown in
http://t.co/c2RCSFINnJ
http://t.co/99RKhu5Aob
Fan dimension is square 50 mm, height 10mm.
To keep i simple, no screws are needed. Fan is clipped in place, and pins together with the slide on lid holds the board.
UART pins must be bent 90 deg in order to slide the lid on. There is a gap on the side for attaching the wires.
Have fun with your parallella!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
![Parallella Case With 12V Fan [Revision 1.0]](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Frenders%2F87%2F0d%2F22%2F5d%2F43%2FParallella_Box_With_Fan_V1_display_large.jpg&w=400&h=300)
