Thingiverse
Parameterizable Gear
von plushvoxel
50
Downloads
28
Likes
0
Makes
This is a parameterizable gear.
You can adjust the number and width of the teeth and the diameter of the mounting hole.
If you set the width of the teeth close to Pi (as per default), the radius of the gear in millimeter will be close to the number of teeth.
You can adjust the number and width of the teeth and the diameter of the mounting hole.
If you set the width of the teeth close to Pi (as per default), the radius of the gear in millimeter will be close to the number of teeth.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
