Thingiverse
Parametric adapter for parasol base
von egil
106
Downloads
69
Likes
1
Makes
This is an adapter to fit various size parasol tubes to various size parasol bases. Perfect if you buy a new parasol but want to reuse your old base, or if you lost your adapter. Most bases has some form of retaining mechanism, so there is a slot for that. If not needed, set the slot width to zero. Also you may want to have a tongue in that slot, in which case you set the tongue width to the desired non-zero value.
It is designed for printing with 100% infill. No support should be needed. ABS is a suitable material, but you may want to compensate for thermal crimping (can be done in customizer). PLA has some issues with temperature stability and UV-sensitivity when used outdoors, but at least in temperate climates it may still hold for a many years. (My oldest print, in PLA, is now 8 years old and is still totally fine.)
The files marked v1 and v2 are old versions, for completeness.
It is designed for printing with 100% infill. No support should be needed. ABS is a suitable material, but you may want to compensate for thermal crimping (can be done in customizer). PLA has some issues with temperature stability and UV-sensitivity when used outdoors, but at least in temperate climates it may still hold for a many years. (My oldest print, in PLA, is now 8 years old and is still totally fine.)
The files marked v1 and v2 are old versions, for completeness.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!