Parametric cable clip with magnet

I wanted to try out a design where I clip my cables to the metal frame of my desk. This design combines a simple clip with a hole for a magnet.

In my case the models for 3x3 magnets worked with friction fit, but a dab of glue or epoxy will probably help keep the magnet in over time.

The file names are formatted as follows:

cableclip-magnet-$clipsize-$magnetdiameterX$magnetheight.stl

If you use the customiser please keep in mind that you'll have to adjust the "clip z offset mm", making sure the clip doesn't poke through into the magnet slot. If anyone has any pointers to how I could improve the formulas: please fork or comment :).

Supports are disabled for now, I was able to print the models pretty well without them.