Parametric cork paint handle

Parameteried cork miniature painting handle The handle accepts a piece of cork that you can place your minitature or sub-assembly on. No more falling over when putting down the model, or hand cramps from holding the small cork for too long. Push-fit your cork to hold it in place. In case you find it difficult to remove the cork again, you will find a hole at the bottom that allows you to push the cork out of the handle again.The model is parameterized. You can adapt the height, and width of the holder, as well as the cork size.The default height of the model is 60mm (2.36in). The default diameter for the cork is 24.25mm (0.95in). As corks come in different sizes you might want to play with the later setting. Personally I have 3 variants for slightly different tolerances. The default print profile has fuzzy skin enabled and print with 0.08 layer height. Change these parameters to your own liking, these settings are only personal preference. I also provided a smooth profile without fuzzy