Thingiverse
Parametric Folding Prop Stop Insert
von wbu42
24
Downloads
25
Likes
2
Makes
# Motivation
I really like the design [1665993](https://www.thingiverse.com/thing:1665993) from [markqv](https://www.thingiverse.com/markqv), but I needed it for the Mayatech (and similar) folding prop yoke. There is even a remix for exactly this: [2514514](https://www.thingiverse.com/thing:2514514), but I had trouble with too much friction, that would need quite a bit of sanding.
# Details
This design should work for a lot of folding props, if you adapt the parameters accordingly. I included the (reverse engineered) parameters for the Aeronaut folding prop as well as the Mayatech + Gemfan ones. But I only tested the Maytech version myself.
As usual I went for a parametric design, to make it easier to adapt things later. This time I tried to use the freecad TechDraw workbench to document all the parameter, which was a bit painful, because it has to be re-done whenever the slightest change is done to the model. But the result looks quite good.
You can easily adapt the fol
I really like the design [1665993](https://www.thingiverse.com/thing:1665993) from [markqv](https://www.thingiverse.com/markqv), but I needed it for the Mayatech (and similar) folding prop yoke. There is even a remix for exactly this: [2514514](https://www.thingiverse.com/thing:2514514), but I had trouble with too much friction, that would need quite a bit of sanding.
# Details
This design should work for a lot of folding props, if you adapt the parameters accordingly. I included the (reverse engineered) parameters for the Aeronaut folding prop as well as the Mayatech + Gemfan ones. But I only tested the Maytech version myself.
As usual I went for a parametric design, to make it easier to adapt things later. This time I tried to use the freecad TechDraw workbench to document all the parameter, which was a bit painful, because it has to be re-done whenever the slightest change is done to the model. But the result looks quite good.
You can easily adapt the fol
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
