Slicer Discord
Parametric Grommet Generator – 3D-Druckmodell von MakerWorld MakerWorld
Other Tools

Parametric Grommet Generator

2.6k Downloads
2.2k Likes
996 Makes
Zum Modell
Parametric Grommet Generator A fully parametric two-piece snap-fit grommet generator. Print both halves, feed your cables through, and snap the two pieces together through your panel. No screws, no adhesive. Supports optional chamfered flanges and an internal fillet for a clean cable entry. Simply change the variables to match your use case and export! Parameters Please refer to the diagram image on this model for a visual representation of each of the parameters available A - Cable Hole Diameter - The clear inner hole the cable(s) pass through. Measure your cable bundle diameter and add a little clearance. B - Panel Hole Diameter - The diameter of the hole cut in your panel. The grommet sleeve sits inside this hole — it should be a snug fit. C - Flange Diameter - The outer diameter of the flanges. Must be larger than your panel hole so the grommet cannot pull through. D - Panel Thickness - The thickness of the panel the grommet clips onto. The slot between the two flanges is sized to
Kategorie
Other Tools
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Fortgeschritten Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Hardware nötig
Supports 1/3
Zusammenbau 2/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

1 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen