Thingiverse
Parametric Hanging Box
door ctheroux
3
Downloads
1
Likes
0
Makes
This openSCAD model generates a box that can be attached using 2 screws on a
wall, aluminum extrusion, etc. They can be offsetted from the center of the
box if needed.
Support material is not required. An infill of 20% is recommended.
This object main web page is:
http://www.ctheroux.com/parametric-hanging-box/.
This object was designed using openSCAD.
You can request the source files on the page listed above.
wall, aluminum extrusion, etc. They can be offsetted from the center of the
box if needed.
Support material is not required. An infill of 20% is recommended.
This object main web page is:
http://www.ctheroux.com/parametric-hanging-box/.
This object was designed using openSCAD.
You can request the source files on the page listed above.
ctheroux publiceert ook op
406 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
