Thingiverse
Parametric Macropad
door Rowb
18
Downloads
14
Likes
0
Makes
This is a parametric model of a handwired macropad with two encoders. You can choose 3x3, 4x4, 5x5, 3x5, 3x4 and so on, you can also change the height, angle, wall thickness and much more. Unfortunately, I am not very good at modeling and there may be errors, I hope you will not encounter them
Standart BOM:
1. STM32F108C8T6 (aka BluePill)
2. Insert Nut m3 L-3mm, OD-4.2mm (x5 pcs)
3. M3x6 countersunk (x2 pcs)
4. M3x12 (x3 pcs)
5. Encoder EC11E 30/15 20mm pushpin (x2 pcs)
Standart BOM:
1. STM32F108C8T6 (aka BluePill)
2. Insert Nut m3 L-3mm, OD-4.2mm (x5 pcs)
3. M3x6 countersunk (x2 pcs)
4. M3x12 (x3 pcs)
5. Encoder EC11E 30/15 20mm pushpin (x2 pcs)
Rowb publiceert ook op
3 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!