Parametric magnetic micro wire clip

Because the difference between too lose and too tight can be often less than 0.2mm I decided to make a lot of variations with small 0.1mm differences between the sizes. It's 20 variations with a 0.1mm difference from the 3.0mm gap up to 5.0mm. That should fit on thin cables up to pretty thick. This solves the differences between printers, if mine would be overextruding and yours underextruding, your part could be lose while mine would fit perfectly, this way everybody can try and chose which one fits well. The print takes few minutes and takes very little filament so feel free to experiment. It was designed for 0.4 nozzles and 0.3 layer height (the separation for the magnet is 0.6mm, so 2 layers should be made there). But overall any common settings should do well (do not print it completely empty in the shell mode). But no support or anything should be needed.

The design is parametric and SolidWorks source is included. If needed a specific dimension can be made per request if someb