Thingiverse
Parametric Prusa PSU Mounting brackets
von devzero
31
Downloads
14
Likes
1
Makes
My 12V 20A power supply that I got from amazon didn't have the same screw holes that all of the other PSU mounts had. The most succesful strategy I had was to use the holes on the bottom of the PSU. I made this parametric in openscad so that you can easily accomodate any sized PSU. It mounts below the y carriage.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!