Parametric quad frame for mini/micro-quads

Simple all-in-one print quad frame for light and small quads.
Fully parametric so you can customize for your own board and motors.
It is designed for those tiny motors that can be used without a "foot" aka they just have a bearing tube out back. This tube can be pressed into the holders saving weight.

Make sure to add enough offset to your motors so you can fit large enough props. The offset is distance from center of board so make sure you take half the prop diameter and add half board width. Then add some clearance margin for the material in controller frame.

I plan on adding extra trays you can fit on top for RX and such as well as a battery-caddy with landing-legs for fitting on bottom.
Finally there may be a canopy that attaches to the top as well.

Edit: Added v1.1 with trays
You can extend the supports/spacers on the trays by setting a parameter ofcource. Use the trays upside down for alternative spacing. They can even be used as battery trays and mounted on und