Slicer Discord
Parametric Secure-ish Temporary Deadbolt Plug – 3D-Druckmodell von Thingiverse Thingiverse

Parametric Secure-ish Temporary Deadbolt Plug

0 Downloads
2 Likes
0 Makes
Zum Modell
You are painting a door, perhaps, or for whatever reason can't put the lock back on your deadbolt before bed. This plug fills the hole and screws in place, without exposing any hardware to the outside, and can probably be ready in 30-60 min.

Is it secure? Maybe, although a perp might drill the plastic clear enough for a screwdriver, which can draw the bolt mechanism. (New) I added a pocket for a washer or coin to muddy the waters against drilling.

Security pointers:
1. Recess and fit the plug tight to the door cutout so that prying the edge is a hassle.
2. (New) Place an M3 washer into the anti-drill pocket (or resize it for a penny). Ideally a drill bit would catch on the washer's ID and spin freely, or if the perp gets aggressive they'll end up rendering your bolt inoperable when they over-drill through the washer. More likely the perp will just get confused after they thought they made it through your plastic but then they can't get their screwdriver to move the bolt. Rememb
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Bemalen, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen