Thingiverse
Parametric Spool Mount for Prusa Mendel
von reprapperMC
4
Downloads
5
Likes
0
Makes
This is a spool mount for the Prusa Mendel to use with the Parametric Filament Spool. http://www.thingiverse.com/thing:8317
This spool mount only uses one piece of M8 thread (or SAE equivalent) and two M8 nuts. The M8 rod I had was a bit long but you can use a shorter piece. I would recommend a piece 20cm or longer.
This spool mount only uses one piece of M8 thread (or SAE equivalent) and two M8 nuts. The M8 rod I had was a bit long but you can use a shorter piece. I would recommend a piece 20cm or longer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
