Parametric teabag box (with stand)

This is a completely parametric teabag holder with suitable stand that can hold 3 of them.

**HOLDER**

Print without supports if your printer can bridge the gap up top. It only has two walls so it's flexible enough to adapt to the baggies inside but not weak. 20% infill is recommended but you can go as low as you want since it only matters in the lid.


**STAND**

The stand has a square on the thinner side because it wouldn't stick and it's not easy to get a brim just on a part of a model, so I decided to include my own in the design. Easily removed with flush cutters or an exacto knife. The rhombus shapes are to save material and time while also giving it a cooler look in my opinion. Again, three walls are just enough for it to be able to withstand the weight of three full boxes without even flexing.