Thingiverse
Parametric universal spool holder
von rowokii
8.2k
Downloads
5.3k
Likes
183
Makes
"Universal Spool Holder 18-56mm II, 606ZZ/608ZZ" by cntrlV seemed like a nice design, but my spool had 60mm hole.
I made a simple parametric version in scad. I added a thin boundary above the bearing, so you need to drill it out or clean up after print, but it makes printing easier. I also made a spacer to put between the bearing and the holder so the bearing does not bind against the holder.
The uploaded stl file is for a 25-70mm holder using 608 bearing.
Update: The hole for the bearing on the uploaded stl is a tight fit (I have it set to 22mm, and 608 bearing has 22mm diameter). Depending on how well your printer is calibrated, you may want to enlarge the diameter a bit.
Update 4/16: Uploaded clip that can be used instead of a nut for quicker changes. Top side of the clip (as printed) goes toward the bearing.
I made a simple parametric version in scad. I added a thin boundary above the bearing, so you need to drill it out or clean up after print, but it makes printing easier. I also made a spacer to put between the bearing and the holder so the bearing does not bind against the holder.
The uploaded stl file is for a 25-70mm holder using 608 bearing.
Update: The hole for the bearing on the uploaded stl is a tight fit (I have it set to 22mm, and 608 bearing has 22mm diameter). Depending on how well your printer is calibrated, you may want to enlarge the diameter a bit.
Update 4/16: Uploaded clip that can be used instead of a nut for quicker changes. Top side of the clip (as printed) goes toward the bearing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
