Cults3D
Various
Zum Modell
Paramotor Propeller Wall Mount
1
Downloads
0
Likes
0
Makes
I designed this spinning propeller wall mount to repurpose a damaged paramotor propeller. The bearings allow the propeller to spin smoothly even with a slight breeze. Attach to the wall using either drywall mounts or directly into the stud.
Parts List Below:
Qty 2x - Bearing 3003-2RS (available from VXB or other online Vendors. Non RS version is unsealed and should only be used indoors.) A washer or Spacer Should be used between the two bearings to prevent over preloading during assembly.
Qty 1x - 5/16 bolt x 1.25 thread
Qty 1x - 5/16 nut (Locking or use Thread Locker)
Qty 6x - M6 Nuts
Qty 6x M6 Socket Head Bolts- the length will depend on the thickness of your propeller hub.
Parts List Below:
Qty 2x - Bearing 3003-2RS (available from VXB or other online Vendors. Non RS version is unsealed and should only be used indoors.) A washer or Spacer Should be used between the two bearings to prevent over preloading during assembly.
Qty 1x - 5/16 bolt x 1.25 thread
Qty 1x - 5/16 nut (Locking or use Thread Locker)
Qty 6x - M6 Nuts
Qty 6x M6 Socket Head Bolts- the length will depend on the thickness of your propeller hub.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!