Thingiverse
Pard NV007S power switch guard
von Joghurt
3
Downloads
6
Likes
0
Makes
The power button of my Pard NV007S is really easy to operate, sometimes switching on my Pard while still in its protective pouch, which I naturally don't notice and therefore every time I take it out I have to switch it on to check the battery.
That's pretty annoying so I designed this button guard.
I cut off three strips of a "Tesa Power-Strip" and used them to put it onto my Pard.
If your fingers are more on the thick side you may want to lower the button guard below the printer surface for slicing (turning it upside-down), so that not its whole height is printed. Keep in mind that the Power-Strip also adds to its height.
That's pretty annoying so I designed this button guard.
I cut off three strips of a "Tesa Power-Strip" and used them to put it onto my Pard.
If your fingers are more on the thick side you may want to lower the button guard below the printer surface for slicing (turning it upside-down), so that not its whole height is printed. Keep in mind that the Power-Strip also adds to its height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!