Parking bumps

My wife got a little too close to our Miata in the garage and while I was looking for something to keep the van from getting too close I found this : http://www.camco.net/product/accupark-10489/
So I decided to try and come up with my own version

Print the interlock test pieces first and make sure they will fit and need no special sizing in your slicer.

You will want to print an additional end piece to cap off the end and as many links as needed for however many middle pieces you print. I would suggest a non rigid or brittle filament such as ABS or PetG that can stand up and bounce back from being run over.

3/16x1.75 tapicons will work perfectly with the countersinks I have. You will need a hammer drill to drill the holes in concrete. Otherwise you can try 3M adhesive tape.