Thingiverse
Parkside Angle Grinder Guard / Shield
von drift_kar
3
Downloads
1
Likes
0
Makes
Print with a small layer hieght 0.2mm is less ideally.
Has a bit of adjust ability with the angle.
Dont over tighten the screws or youll crush the print, use blue locktight on them to stop them vibrating loose.
I plan on lining the inside of mine with foil tape to stop it melting (I used PETG)
Has a bit of adjust ability with the angle.
Dont over tighten the screws or youll crush the print, use blue locktight on them to stop them vibrating loose.
I plan on lining the inside of mine with foil tape to stop it melting (I used PETG)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
