Parrot Disco Mobius Mini Mount

Parrot Disco Mobius Mini Mount

I love my disco, but one of the things that's always let them down is the camera, so I came up with this which is cobbled together from the best bits of various.other camera mounts I've tried.

Print at 0.2 layer height, use a good wide brim for increasedbed adhesion (I used 8mm), and use with supports "everywhere"... then (if you use cura) add a suport BLOCKER that covers everything apart from where the camera goes. By doing this you avoid having all the holes clogged up with pesky to remove support material.

Printing in the orientation shown ensures the best possible combination of support structure while keeping the layer lines in a helpful direction.

Worked a treat on my disco and provides pin sharp footage in stark contrast to the disco's own stabilised but somewhat soft and blurry footage.

Attatch to the plane's canopy with either some good quality double sided foam tape (3m brand recommended) or with 3mm screws that go right through