Partial Moving Parts Conversion

First time Remixing so hope you like it!

I have ADHD and like to fiddle with my prints. The more spinning parts the better.

Added the obvious item of allowing the barrel to rotate forward for fake reloads. Added a locking pin which runs down the middle of the cylinder.

All you need is a small spring glued into the hole barrel side, and the locking pin should slide in, lock into the spring without issue, and then allow the gun to lock in place so the barrel doesn't flop forward.

Feel free to fix whatever you would like to!

I had to resize my locking pin within the slicer software. Dropped the X and Y axis down by 10% while leaving the Z axis at 100% (90/90/100)

I use filament to create the bar that allows the barrel to swing down, but feel free to use whatever fits.

The model doesn't technically combine together into a single print, but all the same this was a fun adventure into customizing a model!

Huge props to the OG uploader!