Party Voting Box w/Lid

I needed a voting box for an upcoming party so that participants could drop in a vote for a costume contest.

This is a super simple print. No supports needed. It is a fairly big print so be prepared for a long print time if using a high resolution setting.

I used wood PLA filament, a 0.6mm nozzle, and a 0.4mm layer setting.
With this material and these settings I was able to print the box and lid in roughly 9 hours.

The lid is a good fit with little movement when placed on top but is not a tight fit. The lid will fall off if the box is flipped over.