Passenger Train Car - Brio Compatible

These small passenger cars are great for transporting your townspeople wherever they need to go. They are compatible with Brio, Ikea, and most other wooden trains. Parts List (per car):4x M2 cap head screws 6-12mm length4x M2 washers2x 10x4x3mm ring magnets2x 10mm diameter metal push pinsA touch of CA gluePrinting Instructions:Print 4 wheels, flat side downPrint one base piece, upside down orientation, some supports are required.Print one each core and body, no supports are required.Print one roof, some supports are required.Assembly should be fairly straightforward.The wheels are each secured to the base with an M2 cap head screw, with a washer in-between the wheel and the base. Don't over tighten the wheels, they should spin freely and even have a bit of wiggle. The core sits in the slot in the base, A drop or two of CA glue holds them together. The body slides over the core, again a touch of CA glue is your friend.Finally the roof piece slides on top. Be aware that any stringing